PoE/RS485 Add-On Card for IFC6309 Micro SBC and IFC6640 SBC
This is an excellent accessory for situations when you want to connect network devices that are far away from your power source. With this accessory, you can now power your IFC6309 and IFC6640 platforms and provide an Ethernet connection in any location with just a single cable! You also get an isolated full duplex RS-485 transceiver with Signalling Rates up to 4 Mbps. The accessory comes with the necessary spacers and connector to interface to the IFC6309 and IFC6640 platforms.
Block Diagram
Specifications
PoE/RS485 Accessory Specifications
- PD configuration for PoE where the board gets power from PoE-enabled switches
- The add-on card gives out 12V DC output. An external 12V, 1A Jack with Lock is available
- The connection between ACC-1S70 and IFC6309 or IFC6640 platforms is through a 10 pin header; 12V power supply is given through this header
- Conflict of power sources when DC power jack and PoE-enabled switches are both connected is handled; The higher voltage source shall be chosen to drive the board.
- PoE is 25.5W IEEE 802.3 at Compliant (Type 2) PD
- 1.5KV isolation input to output; Undervoltage and overvoltage supported with thermal protection
- Short-circuit protection with auto-restart
- Isolated Full Duplex RS-485 transceiver
- RS-485 meets TIA/EIA RS-485 requirements; Signalling rates up to 4 Mbps; 50 kV/μs typical transient immunity
Power, Mechanical, and Environmental
- Module dimensions: 85mm x 54mm x 25.6mm; 54 grams
- Connector : 10-pin header and necessary spacers
- Power: 12V/1A DC output
- Extended operating temperature range of -20ºC to +70ºC
Compatible Platforms
- IFC6309 Micro SBC
- IFC6640 SBC